Stop 0xC0000221 or STATUS_IMAGE_CHECKSUM_MISMATCH This Stop message indicates driver, system file, or disk corruption problems (such as a damaged paging file). Faulty memory hardware can also cause this Stop message to appear. Possible Resolutions: • You can use Driver Rollback or System Restore from safe mode, to restore a previous driver. You can also use [...]

Stop 0x000000ED or UNMOUNTABLE_BOOT_VOLUME The kernel mode I/O subsystem attempted to mount the boot volume and it failed. This error might also occur during an upgrade to Windows XP Professional on systems that use higher throughput ATA disks or controllers with incorrect cabling. In some cases, your system might appear to work normally after you [...]

Stop 0x000000EA or THREAD_STUCK_IN_DEVICE_DRIVER A device driver problem is causing the system to pause indefinitely. Typically, this problem is caused by a display driver waiting for the video hardware to enter an idle state. This might indicate a hardware problem with the video adapter or a faulty video driver. Possible Resolutions: • Stop 0xD1 messages [...]

Stop 0x000000D1 or DRIVER_IRQL_NOT_LESS_OR_EQUAL The Stop 0xD1 messages indicates that the system attempted to access pageable memory using a kernel process IRQL that was too high. Drivers that have used improper addresses typically cause this error. Possible Resolutions: • Stop 0xD1 messages can occur after installing faulty drivers or system services. If a driver is [...]

Stop 0x000000CE or DRIVER_UNLOADED_WITHOUT _CANCELLING_PENDING_OPERATIONS This Stop messages indicates that a driver failed to cancel pending operations before exiting. Possible Resolutions: • Stop 0xCE messages can occur after installing faulty drivers or system services. If a driver is listed by name, disable, remove, or roll back that driver to confirm that this resolves the error. [...]

Stop 0xC2 or BAD_POOL_CALLER The Stop 0xC2 message indicates that a kernel-mode process or driver incorrectly attempted to perform memory operations in the following ways: • By allocating a memory pool size of zero bytes. • By allocating a memory pool that does not exist. • By attempting to free a memory pool that is [...]

Stop 0xBE or ATTEMPTED_WRITE_TO_READONLY_MEMORY The Stop 0xBE message indicates that a driver attempted to write to read-only memory. Possible Resolutions: • A Stop 0xBE message might occur after installing a faulty device driver, system service, or firmware. If a Stop message lists a driver by name, disable, remove, or roll back the driver to correct [...]

Stop 0x0000009F or DRIVER_POWER_STATE_FAILURE The Stop 0x9F message indicates that a driver is in an inconsistent or invalid power state. Possible Resolutions: • Stop 0x9F messages can occur after installing faulty applications or drivers or system services. If a file is listed by name and you can associate it with an application, uninstall the application. [...]

Stop 0x0000007F or UNEXPECTED_KERNEL_MODE_TRAP The Stop 0x7F message indicates that one of three types of problems occurred in kernel-mode: • A condition that the kernel is not allowed to have or intercept (also known as a bound trap). • Software problems. • Hardware failures. Possible Resolutions: • Stop 0x7F messages are typically due to defective, [...]

Stop 0x0000007B or INACCESSIBLE_BOOT_DEVICE The Stop 0x7B message indicates that Windows XP has lost access to the system partition or boot volume during the startup process. Installing incorrect device drivers when installing or upgrading storage adapter hardware typically causes stop 0x7B errors. Stop 0x7B errors could also indicate possible virus infection. The second parameter is [...]

Stop 0x0000007A or KERNEL_DATA_INPAGE_ERROR The Stop 0x7A message indicates that a page of kernel data was not found in the paging (virtual memory) file and could not be read into memory. This might be due to incompatible disk or controller drivers, firmware, or hardware. Frequently, the cause of this error can be determined from the [...]